Male vasectomy surgery process diagram

In order to prevent pregnancy, many methods have been adopted. Sterilization is a permanent method. It is for this reason that many couples who do not want to have children choose this method of contraception. However, before carrying out the sterilization operation, it is necessary to understand the whole process of this surgical treatment, which is also helpful for the safe operation. The following is a discussion of the whole process of male sterilization.

1. Sterilize the endoscope three times with warm 0.1% benzalkonium bromide solution (1:1000 new gentamicin solution) and cover the hole with a towel. Use the thumb and middle thumb of your right hand to find the ejaculatory duct in the front of the scrotum, and squeeze it firmly into the subcutaneous tissue, and pinch the firm ejaculatory duct. Apply local anesthesia to the skin where the ejaculatory duct is fixed, and push the medicine while inserting the needle, so that the medicine diffuses from the skin to the periphery of the ejaculatory duct.

2. Use a small sharp knife to make a small incision at the local anesthesia injection site, with the incision length not exceeding 0.4 cm. Separate the ejaculatory duct and fix it with a clamp to go straight through the ejaculatory duct, and slightly separate it along the longitudinal coordinate of the ejaculatory duct. Then insert the ejaculatory duct fixing clamp into the incision, pinch the ejaculatory duct and pull it out of the incision.

3. Use mosquito forceps to separate the tunica vaginalis and blood vessels of the ejaculatory duct. After the ejaculatory duct is stretched out 1-1.5cm, use two mosquito hemostatic forceps to clamp the ejaculatory duct on the left and right sides of the separated section, and then remove the fixed forceps.

4. Cut off and ligate a part of the ejaculatory duct that was separated during the ligation operation. After twisting it with a hemostatic forceps, use No. 1 thread to ligate both sides of the operation, with an interval of 1.5 cm. Lift the ligation thread and cut off about 1 cm of the ejaculatory duct. Check if there is any bleeding, cut off the ligation thread, and protect the separated broken end with the distal side with the external muscle fascia of the spermatic flexor. Then put it into the skin wound and promote blood circulation carefully. The skin wound does not need to be sutured surgically, but the two ends of the skin edge must be aligned.

5. Use the same method to solve the ejaculatory duct on the other side. After the operation, cover the wound with sterile gauze and fix it with tape.

The above is the actual whole process of sterilization. Before the surgery, you should have a proper scientific understanding of the surgery, and you don't have to worry about it. This surgery will not affect the human body. After the surgery is successful, it is actually necessary to undergo 2 sperm tests to confirm that there are no sperms to be considered a complete contraceptive measure. Therefore, it is necessary to have a certain understanding of sterilization.